(a) Emission specifications for the Mass Emission Cap and Trade Program. The nitrogen oxides (NOX ) emission rate values used to determine allocations for Chapter 101, Subchapter H, Division 3 of this title (relating to Mass Emissions Cap and Trade Program) must be the lower of any applicable permit limit in a permit issued before January 2, 2001; any permit issued on or after January 2, 2001, that the owner or operator submitted an application determined to be administratively complete by the executive director before January 2, 2001; any limit in a permit by rule under which construction commenced by January 2, 2001; or the following emission specifications:
  (1) gas-fired boilers:
    (A) with a maximum rated capacity equal to or greater than 100 million British thermal units per hour (MMBtu/hr), 0.020 pounds per million British thermal units (lb/MMBtu);
    (B) with a maximum rated capacity equal to or greater than 40 MMBtu/hr, but less than 100 MMBtu/hr, 0.030 lb/MMBtu; and
    (C) with a maximum rated capacity less than 40 MMBtu/hr, 0.036 lb/MMBtu (or alternatively, 30 parts per million by volume (ppmv) NOX , at 3.0% oxygen (O 2 ), dry basis);
  (2) fluid catalytic cracking units (including carbon monoxide (CO) boilers, CO furnaces, and catalyst regenerator vents), one of the following:
    (A) 40 ppmv NOX at 0.0% O2 , dry basis;
    (B) a 90% NOX reduction of the exhaust concentration used to calculate the June - August 1997 daily NOX emissions. To ensure that this emission specification will result in a real 90% reduction in actual emissions, a consistent methodology must be used to calculate the 90% reduction; or
    (C) alternatively, for units that did not use a continuous emissions monitoring system (CEMS) or predictive emissions monitoring system (PEMS) to determine the June - August 1997 exhaust concentration, the owner or operator may:
      (i) install and certify a NOX CEMS or PEMS as specified in §117.340(f) or (g) of this title (relating to Continuous Demonstration of Compliance) no later than June 30, 2001;
      (ii) establish the baseline NOX emission level to be the third quarter 2001 data from the CEMS or PEMS;
      (iii) provide this baseline data to the executive director no later than October 31, 2001; and
      (iv) achieve a 90% NOX reduction of the exhaust concentration established in this baseline;
  (3) boilers and industrial furnaces (BIF units) that were regulated as existing facilities in 40 Code of Federal Regulations (CFR) Part 266, Subpart H (as was in effect on June 9, 1993):
    (A) with a maximum rated capacity equal to or greater than 100 MMBtu/hr, 0.015 lb/MMBtu; and
    (B) with a maximum rated capacity less than 100 MMBtu/hr:
      (i) 0.030 lb/MMBtu; or
      (ii) an 80% reduction from the emission factor used to calculate the June - August 1997 daily NOX emissions. To ensure that this emission specification will result in a real 80% reduction in actual emissions, a consistent methodology must be used to calculate the 80% reduction;
  (4) coke-fired boilers, 0.057 lb/MMBtu;
  (5) wood fuel-fired boilers, 0.060 lb/MMBtu;
  (6) rice hull-fired boilers, 0.089 lb/MMBtu;
  (7) liquid-fired boilers, 2.0 pounds per 1,000 gallons of liquid burned;
  (8) process heaters:
    (A) other than pyrolysis reactors:
      (i) with a maximum rated capacity equal to or greater than 40 MMBtu/hr, 0.025 lb/MMBtu; and
      (ii) with a maximum rated capacity less 40 MMBtu/hr, 0.036 lb/MMBtu (or alternatively, 30 ppmv NOX , at 3.0% O2 , dry basis); and
    (B) pyrolysis reactors, 0.036 lb/MMBtu;
  (9) stationary, reciprocating internal combustion engines:
    (A) gas-fired rich-burn engines:
      (i) fired on landfill gas, 0.60 grams per horsepower-hour (g/hp-hr); and
      (ii) all others, 0.50 g/hp-hr;
    (B) gas-fired lean-burn engines, except as specified in subparagraph (C) of this paragraph:
      (i) fired on landfill gas, 0.60 g/hp-hr; and
      (ii) all others, 0.50 g/hp-hr;
    (C) dual-fuel engines:
      (i) with initial start of operation on or before December 31, 2000, 5.83 g/hp-hr; and
      (ii) with initial start of operation after December 31, 2000, 0.50 g/hp-hr; and
    (D) diesel engines, excluding dual-fuel engines, placed into service before October 1, 2001, that have not been modified, reconstructed, or relocated on or after October 1, 2001, the lower of 11.0 g/hp-hr or the emission rate established by testing, monitoring, manufacturer's guarantee, or manufacturer's other data. For the purposes of this subparagraph, the terms "modification" and "reconstruction" have the meanings defined in §116.10 of this title (relating to General Definitions) and 40 CFR §60.15 (December 16, 1975), respectively, and the term "relocated" means to newly install at an account, as defined in §101.1 of this title (relating to Definitions), a used engine from anywhere outside that account; and
    (E) for diesel engines, excluding dual-fuel engines, not subject to subparagraph (D) of this paragraph:
      (i) with a horsepower rating of less than 11 horsepower (hp) that are installed, modified, reconstructed, or relocated:
        (I) on or after October 1, 2001, but before October 1, 2004, 7.0 g/hp-hr; and
        (II) on or after October 1, 2004, 5.0 g/hp-hr;
      (ii) with a horsepower rating of 11 hp or greater, but less than 25 hp, that are installed, modified, reconstructed, or relocated:
        (I) on or after October 1, 2001, but before October 1, 2004, 6.3 g/hp-hr; and
        (II) on or after October 1, 2004, 5.0 g/hp-hr;
      (iii) with a horsepower rating of 25 hp or greater, but less than 50 hp, that are installed, modified, reconstructed, or relocated:
        (I) on or after October 1, 2001, but before October 1, 2003, 6.3 g/hp-hr; and
        (II) on or after October 1, 2003, 5.0 g/hp-hr;
      (iv) with a horsepower rating of 50 hp or greater, but less than 100 hp, that are installed, modified, reconstructed, or relocated:
        (I) on or after October 1, 2001, but before October 1, 2003, 6.9 g/hp-hr;
        (II) on or after October 1, 2003, but before October 1, 2007, 5.0 g/hp-hr; and
        (III) on or after October 1, 2007, 3.3 g/hp-hr;
      (v) with a horsepower rating of 100 hp or greater, but less than 175 hp, that are installed, modified, reconstructed, or relocated:
        (I) on or after October 1, 2001, but before October 1, 2002, 6.9 g/hp-hr;
        (II) on or after October 1, 2002, but before October 1, 2006, 4.5 g/hp-hr; and
        (III) on or after October 1, 2006, 2.8 g/hp-hr;
      (vi) with a horsepower rating of 175 hp or greater, but less than 300 hp, that are installed, modified, reconstructed, or relocated:
        (I) on or after October 1, 2001, but before October 1, 2002, 6.9 g/hp-hr;
        (II) on or after October 1, 2002, but before October 1, 2005, 4.5 g/hp-hr; and
        (III) on or after October 1, 2005, 2.8 g/hp-hr;
      (vii) with a horsepower rating of 300 hp or greater, but less than 600 hp, that are installed, modified, reconstructed, or relocated:
        (I) on or after October 1, 2001, but before October 1, 2005, 4.5 g/hp-hr; and
        (II) on or after October 1, 2005, 2.8 g/hp-hr;
      (viii) with a horsepower rating of 600 hp or greater, but less than or equal to 750 hp, that are installed, modified, reconstructed, or relocated:
        (I) on or after October 1, 2001, but before October 1, 2005, 4.5 g/hp-hr; and
        (II) on or after October 1, 2005, 2.8 g/hp-hr; and
      (ix) with a horsepower rating of 750 hp or greater that are installed, modified, reconstructed, or relocated:
        (I) on or after October 1, 2001, but before October 1, 2005, 6.9 g/hp-hr; and
        (II) on or after October 1, 2005, 4.5 g/hp-hr;
  (10) stationary gas turbines:
    (A) rated at 10.0 megawatts (MW) or greater, 0.032 lb/MMBtu;
    (B) rated at 1.0 MW or greater, but less than 10.0 MW, 0.15 lb/MMBtu; and
Cont'd...