For the purposes of determining operational readiness following completion of physical construction of a hazardous waste incinerator, the commission shall establish permit conditions including, but not limited to, specification of allowable waste feeds and operating conditions, in a permit for a new hazardous waste incinerator. These permit conditions will be effective for a minimum required time, not to exceed 720 hours operating time for treatment of hazardous waste, to bring the incinerator to a point of operational readiness sufficient to conduct a trial burn. The commission may extend the duration of this operational period once, for up to 720 additional hours, at the request of the applicant when good cause is shown. The permit may be modified to reflect the extension pursuant to §305.69 of this title (relating to Solid Waste Permit Modification at the Request of the Permittee).
  (1) Applicant must submit a statement, with Part B of the permit application, which suggests the conditions necessary to operate in compliance with the performance standards of 40 Code of Federal Regulations §284.343 during this period. This statement should include, at a minimum, restrictions on waste constituents, waste feed rates, and the operating parameters identified in 40 Code of Federal Regulations §264.345.
  (2) The executive director shall review this statement and any other relevant information submitted with Part B of the permit application and shall specify requirements for this period sufficient to meet the performance standards of 40 Code of Federal Regulations §264.343, based on the executive director's engineering judgment.

Source Note: The provisions of this §305.171 adopted to be effective June 19, 1986, 11 TexReg 2600; amended to be effective October 29, 1990, 15 TexReg 6015.