Sec. 372.006.  NONWATER-SUPPLIED URINAL PERFORMANCE STANDARDS.  (a)  A person may not sell, offer for sale, or distribute in this state a nonwater-supplied urinal for use in this state unless the nonwater-supplied urinal:
(1)  meets the performance, testing, and labeling requirements prescribed by the following standards, as applicable:
(A)  American Society of Mechanical Engineers Standard A112.19.19-2006 "Vitreous China Nonwater Urinals"; or
(B)  International Association of Plumbing and Mechanical Officials Standard ANSI Z124.9-2004 "Plastic Urinal Fixtures";
(2)  provides a trap seal that complies with the building code of the local government in which the urinal is installed; and
(3)  permits the uninhibited flow of waste through the urinal to the sanitary drainage system.
(b)  The manufacturer or importer must submit to the commission certified test results from a laboratory accredited by the American National Standards Institute verifying that the nonwater-supplied urinal conforms to the requirements described by Subsection (a)(1).
(c)  A person who installs a nonwater-supplied urinal shall install water distribution and fixture supply piping sized to accommodate a water-supplied urinal to an in-wall point immediately adjacent to the nonwater-supplied urinal location so that the nonwater-supplied urinal can be replaced with a water-supplied urinal if desired by the owner or required by a code enforcement officer.
(d)  A person who owns a nonwater-supplied urinal shall clean and maintain the nonwater-supplied urinal in accordance with the manufacturer's instructions.
Added by Acts 2009, 81st Leg., R.S., Ch. 1316 (H.B. 2667), Sec. 3, eff. September 1, 2009.